MITSUBISHI ELECTRIC FC810 - Manual (Page 31)

      
     
 
    
      
   
MITSUBISHI ELECTRIC MOTHERBOARD DIVISION PAGE 31 OF 45
  (' 
  

36h Warm start shut down
37h Reinitialise the chipset (MB only)
38h Shadow system BIOS ROM
39h Reinitialise the cache (MB only)
3Ah Autosize cache
3Ch Advanced configuration of chipset registers
3Dh Load alternate registers with CMOS values
42h Initialise interrupt vectors
44h Initialise BIOS interrupts
45h POST device initialisation
46h Check ROM copyright notice
48h Check video configuration against CMOS
49h Initialise PCI bus and devices
4Ah Initialise all video adapters in system
4Bh Display QuietBoot screen
4Ch Shadow video BIOS ROM
4Eh Display BIOS copyright notice
50h Display CPU type and speed
51h Initialise EISA board
52h Test keyboard
54h Set key click if enabled
56h Enable keyboard
58h Test for unexpected interrupts
59h Initialise POST display service
5Ah Display prompt "Press F2 to enter SETUP"
5Bh Disable CPU cache
5Ch Test RAM between 512 and 640 KB
5Eh Base address
60h Test extended memory
62h Test extended memory address lines
64h Jump to UserPatch1
66h Configure advanced cache registers
67h Initialise Multi Processor APIC
68h Enable external and CPU caches
69h Setup System Management Mode (SMM) area
6Ah Display external L2 cache size
6Bh Customise defaults
6Ch Display shadow- area message
6Eh Display possible high address for UMB recovery