Miele G 2630 SCi - Manual (Page 42)

Rinse aid
For best results the rinse aid dosage
can be adjusted.
The dosage can be set between 0 and
6 ml.
The dosage set by default to 3 ml of
rinse aid per program.
^ Use a higher setting if spots appear
on dry glassware.
^ Use a lower setting if streaking
appears on dishes or glasses.
^ Select the desired rinse aid amount
and confirm with OK.
Filter check
h
This selection allows you to set the
number of cycles run before the filter
check message shows.
You can select between 30 and 60
cycles.
The filter check message is set by
default to 40 cycles.
^ Select the desired number of cycles
and confirm with OK.
See "Cleaning and Care - Triple filter
system" for more information.
Adjust Sensor Wash
The "Sensor Wash" program can be
adjusted to clean stubborn but normal
soiling.
^ Select Yes and confirm with OK .
Reorganize program list
k
The order of the programs in the
program list can be reorganized. The
three most frequently used programs
can be saved to the first three
positions.
C Back A
k 1. Normal
2. Pots + Pans e
^ Select from the first three programs
the one, which you would like
removed from the top three..
^ Confirm with OK.
C Starch -
j Cheese
Sani Wash e
^ Select the program to be saved to
the position of the previously
selected program.
^ Confirm with OK.
The reorganizing is confirmed and the
new order of programs is shown.
C Back A
k 1. Cheese
2. Pots + Pans e
^ Reorganize another program or
switch back to "Settings J" with
Back .
Settings
J
42