Motorola Cell Phon User Manual
Page 142
142
I tried to place a
call and received a
fast busy signal.
The cellular system did not process your call. For
example, the cellular system may be overloaded with
call attempts. To redial, press
S
before ending your
call attempt, or press
e
and try the call again later.
(See “Redialing a Number” on page 34.)
I tried to place a
call and received
an alternating
high/low tone.
Your call did not reach the cellular system. You may have
dialed the number too soon after turning the phone on.
Wait until the “NS” light stops blinking before placing a
call.
An alternating tone may also indicate that your phone’s
signal is blocked. Be sure you’re clear of any
obstructions such as bridges, parking garages, or tall
buildings.
I tried to listen to
my Voice Mail (or
use a paging
service, a calling
card, etc.) but
nothing happened.
You may have turned off the Scratchpad tones. Place
your call, enter the access numbers when prompted by
the recording, then press
r
S
. To avoid this
problem in the future, follow the directions “Turning
Scratchpad Tones On and Off” on page 84 to turn the
Scratchpad tones on.
My phone was
stolen. What
should I report and
to whom?
Report a stolen phone to the police and to your service
provider (the company that sends you your monthly
cellular service bills).
I tried to place a
calling card call
using the internal
Phone Book, but it
didn’t work.
You may have turned off your Scratchpad tones. Follow
the directions in “Turning Scratchpad Tones On and Off”
on page 84 to turn the Scratchpad tones on.
Check that you stored your calling card information in
the correct order, and make sure the groups of numbers
are separated by pauses. The easiest way to correct the
sequence may be to start from scratch. Follow the
instructions on “Storing Calling Card Information” on
page 58, enter your calling card information again, and
store it in the same memory location as your previous
attempt.
Also keep in mind that when using your calling card, you
must enter the number you are calling with the area
code, but without the initial “1.” Check with your long
distance carrier for details on using your calling card.
Question
Answer