Mitel WAP54GP - Manual (Page 32)

26 Chapter 6: Configuring the Wireless-G Access Point with Power Over Ethernet
The AP Mode Tab
Wireless-G Access Point with Power Over Ethernet
Wireless Repeater
When set to Wireless Repeater mode, the Access Point receives the signal from the remote Access Point and
retransmits its signal. (This feature only works with the Linksys Wireless-G Exterior Access Point (model number:
WAP54GPE) and Wireless-G Interior Access Point (model number: WAP54GP).
To configure a Wireless Repeater environment, click Wireless Repeater and enter the MAC addresses of the
remote access points in the MAC fields. If you do not know an access point’s MAC address, click the Site Survey
button. Select the access points you want to use and click the Apply button. Then click the Close button to return
to the AP Mode screen. If you do not see the access point you want, click the Refresh button to run another site
survey.
Figure 6-17: Wireless Repeater