Mitel WAP54GP - Manual (Page 42)

36 Chapter 6: Configuring the Wireless-G Access Point with Power Over Ethernet
The Status - Wireless Tab
Wireless-G Access Point with Power Over Ethernet
The Status - Wireless Tab
The Wireless screen displays the Access Point’s current status information for the wireless network(s).
Wireless Network
MAC Address. The MAC Address of the Access Point’s wireless interface is displayed here.
Mode. The Access Point’s wireless network mode is displayed here.
Main SSID. The Access Point’s primary SSID is displayed here.
Virtual SSID1-7. The Access Point’s alternative SSIDs are displayed here.
Channel. The Access Point’s Channel setting for the primary SSID is shown here.
VLAN Trunk. This shows if VLAN Trunk is enabled on this Access Point.
Priority. This shows if 802.1p Priority Setting is enabled on this Access Point.
Main SSID & Virtual SSID1-7 Security Mode. This column shows if any type of wireless security (e.g. WEP,
WPA-Enterprise, etc.) is enabled for a given SSID.
Main SSID & Virtual SSID1-7 Priority. This column shows 802.1p priority setting for a given SSID. It shows
Disabled if Priority feature is not enabled.
To update the status information, click the Refresh button. Help information is displayed on the right-hand side of
the screen.
Figure 6-26: Status - Wireless