Mitel WAP54GP - Manual (Page 34)

28 Chapter 6: Configuring the Wireless-G Access Point with Power Over Ethernet
The Administration - Management Tab
Wireless-G Access Point with Power Over Ethernet
The Administration - Management Tab
On this screen you can configure the password, Web Access, and SNMP settings.
AP Password
You should change the username/password that controls access to the Access Point’s Web-based Utility.
Local AP Password
User Name. Modify the administrator username. The default is admin.
AP Password. Modify the administrator password for the Access Point’s Web-based Utility. The default is admin.
Re-enter to confirm. To confirm the new Password, enter it again in this field.
Web Access
To increase the security on accessing Web-based Utility. You can enable HTTPS. Once enabled, users need to use
https:// when accessing the Web-based Utility.
Web HTTPS Access. Use secured HTTP session to access Web based Utility. The default is Disabled.
Wireless Web Access. Allow or deny wireless clients to access Web based Utility. The default is Enabled.
SNMP
SNMP is a popular network monitoring and management protocol. It provides network administrators with the
ability to monitor the status of the Access Point and receive notification of any critical events as they occur on the
Access Point.
To enable the SNMP support feature, select Enabled. Otherwise, select Disabled. The default is Disabled.
Identification
Contact. Enter the name of the contact person, such as a network administrator, for the Access Point.
Figure 6-19: Administration - Management