Miele W4802 - Manual (Page 34)

The program was canceled, the buzzer sounds and the "Start"
button flashes.
Issue Possible cause Solution
– To turn off the fault message:
Open the drum door or press
and hold the "Pause/Hold to
Cancel" button until the fault
message goes out.
The "FAULT" indicator
"Drain" lights. – The drain is
blocked.
– The drain hose is
too high.
– Clean the drain filter and the
drain pump.
– The maximum drain pump
height is 3 ft (1 m).
The "FAULT" indicator
"Intake" lights. The water intake is
blocked. Possible fault:
– Check if the water supply is
open all the way.
– the inlet hose is kinked.
The "FAULT"
indicators "Intake"
and "Drain" light. The waterproof
system has
activated. Contact Technical Service.
The "STATUS"
indicators "Pre-Wash"
and "Main Wash"
light. There is a fault. Start the program once more.
If the fault message appears
again call Technical Service.
The buzzer sounds
and the "Buzzer"
indicator lights. The door is not
closed properly. – Open the door and check for
any obstructions.
– Close the door.
– Press "Pause/Hold to Cancel"
for at least 5 seconds.
– Press "Start".
Frequently asked questions
30