Memorex MMP8620 - Manual (Page 7)

CHARGING THE BATTERY
7
This unit has a built-in Lithium Polymer rechargeable battery. When the bars
in the battery indicator (in the display) become low (see Figure 1) and
especially when the bars turn red, recharge the battery as follows.
1. Connect the USB cable to the USB jack on the bottom of
this unit (as shown) and to the USB port on your computer;
“✓ OK to Remove” will appear on the screen. When
charging, the battery indicator will flash between empty and
the current charge. Once the battery is fully charged, the
indicator will stop flashing.
NOTES:
• To disconnect this unit from your computer, make sure to follow the “Safely Remove
Hardware” instructions on page 33.
• It takes approx. 3 hours to charge the battery from empty to full. When fully charged,
the unit can playback for approx. 20 hours in Music Playback mode. (Actual playback
times may vary.)
• For data transfer, please use the USB cable (included) to connect the unit to
your computer.
• “Low Battery Voltages” will appear in the display when the battery is empty.
• When the battery is empty and connected to the computer for charging, it may take a
few minutes for the “✓ OK to Remove” screen to be displayed.
Figure 1