Meridian America 506 - Manual (Page 23)

Setting up the CD player
18
To connect to other Meridian 500
Series equipment
● Connect one of the COMMS sockets on the back panel of the
CD player to one of the COMMS socket on another 500 Series
unit, using the 500 comms lead provided with the other unit.
The sequence in which you connect the units is not important.
COMMS COMMS
Then configure the units with the following automatic setup
procedure:
● Switch all the units to standby.
● Press Clear on the remote.
Each unit will display:
Auto
One unit will then be designated
as the controller, and display:
Con.
This is the unit that will respond to the remote.
All the other units will be configured
as non-controllers, and display:
N.Con.
Your system is now set up and ready for use.
● If for any reason the automatic setup does not give the
configuration you want, restore the default operation by
selecting Type 1 as described in To connect to Meridian 600
or 200 Series equipment, page 20.
Note: Do not, under any circumstances, connect any equipment
other than Meridian 500, 600, or 200 Series to the socket
marked COMMS on the back of the CD player.