Moffat 350A4502P5661 - Manual (Page 10)

10
FOR 7” ROUND VERTICAL
DUCTED DISCHARGE
INSTALLATIONS ONLY:*
Bend up the duct alignment ears in preparation for
later attachment of the 7” duct.
7
Installation Instructions
Attachment ear tabs
FOR RECESSED-BOTTOM
CABINETS ONLY* 8
Wood shims
(minimum thickness 3/8” )
• If the cabinets have front, side or back trim, make
2 wood shims a minimum of 3/8” thick and cut to
fit the width of the inner recessed cabinet bottom.
Attach them to the cabinet bottom recess on both
sides. See Step 11 for marking locations.
MARK HOLES*
Select the vent option that your installation will
require and proceed to that section:
Hood mounting screws (4)
13¾” (30” hood)
16¾” (36” hood) 13¾” (30” hood)
16¾” (36” hood)
Cabinet front
Center
line
Electrical access hole
(in cabinet bottom)
Wood shims
(recessed-bottom cabinets
only–shims must be a
minimum of 3/8
” thick
and cut to fit the width
of the inner recessed
cabinet bottom)
Vertical duct
access hole
9 5 / 8 ”
1 3 /
8
”
1¼”
7¾”
3¾”
½”
A.Outside top exhaust
(Vertical duct–3¼ ” x 10 ” Rectangular)
• Use the diagram or the hood as a template and
mark the locations on the cabinet for ductwork,
electrical wiring and keyhole screw slots.
B.Outside top exhaust (Vertical duct–7 ” Round)
• Use the diagram or the hood as a template and
mark the locations on the cabinet for ductwork,
electrical wiring and keyhole screw slots.
Hood mounting screws (4)
13¾” (30” hood)
16¾” (36” hood)
13¾” (30” hood)
16¾” (36” hood)
Cabinet front
Center
line
Electrical access
hole
(in cabinet bottom)
Wood shims
(recessed-bottom cabinets
only–shims must be a minimum
of 3/8
” thick and cut to fit the
width of the inner recessed
cabinet bottom)
Access
hole for 7
”
round duct
9 5 / 8 ”
1 3 / 8 ”
1¼”
7¾”
5¾”
Cabinet
bottom
8 ” DIA.
HOLE
Cabinet Bottom
9
5¼” 5¼”
* 1” = 2.5 cm