Moffat 350A4502P5661 - Manual (Page 12)

12
Installation Instructions
SECURE HOOD
Slide the hood back against the wall. Tighten
the mounting screws. Be sure the screw heads
are in the narrow neck of the keyhole slot.
Keyhole (4)
Mounting
screw (4)
NOTE: DO NOT PUSH ON FAN BLADE. Pushing
on the blade may cause it to interfere with other
hood parts.
15
CONNECT DUCTWORK TO
HOOD (Ducted installations only)*
On 7” round installations, attach the 7” duct
with sheet metal screws through the holes in
the alignment ears.
Use duct tape to make joints secure and air tight.
Duct tape
16
Attachment ear tabs
7” round duct
FOLLOW ELECTRICAL CODE
Complete the electrical wiring according to
National Electrical Code and local codes.
NOTE:
This hood must be permanently grounded.
Connect house wiring (120 VAC) to hood wiring.
18
INSTALL LIGHT BULB
NOTE: A light bulb is not shipped with the hood.
Obtain one locally. Purchase and install an ordinary
screw-base light bulb, not more than 60 watts.
17
CONNECT WIRING
Connect house black to hood black wire, house
white to hood white wire and house ground under
green ground screw
. Securely tighten the strain
relief clamp onto the house wiring.
Green ground screw
19
WARNING: IMPROPER CONNECTION OF
ALUMINUM HOUSE WIRING TO THESE
COPPER LEADS CAN RESULT IN A SERIOUS
PROBLEM. USE ONLY CONNECTORS
DESIGNED FOR JOINING COPPER TO
ALUMINUM AND FOLLOW THE
MANUFACTURER’S RECOMMENDED
PROCEDURE CLOSELY.
* 1” = 2.5 cm