Mustek TP-6000 - Manual (Page 13)

TP6000 USER’S MANUAL 3 - 1
INSTALLATION GUIDES
CAUTION: Before installing any cables or peripherals to the terminal, please
always make certain that the system is turned off and the external
power source is removed to prevent electric hazard! Never touch
any pins within the connectors or circuits to avoid high voltage
hazard or electrostatic discharge. Failure to follow this caution may
cause damage to the unit.
SEPARATING MAIN UNIT
In order to properly install the TP-6000 terminal, all cables must be routed
through its base. Therefore, please press the lock/release button at the rear side to
separate the main unit from the stand assembly.
However, in view of the mass distribution of the whole assembly, it is most
recommended to lay the system facing down on front panel over a soft clean flat
surface first. Press the button and slide the stand assembly to the panel downward side
to detach the stand assembly away from the back of the main unit could then be an
easier operation. This approach can also be applied when later on the main unit and
the stand assembly have to be reunited.
Press the Lock/Release button
and slide the stand assembly
to the panel downward side
to detach it from the main
unit.