Mustek TP-6000 - Manual (Page 19)

TP6000 USER’S MANUAL 3 - 7
marked “signal cable from POS Printer” at the rear of each cash drawer. The cable
lengths for the two 8 pin plugs are different. Use the shorter one for the first cash
drawer “CR1” and use the longer one for the second cash drawer “CR2” that will be
controlled by the application software. Using this method, the TP6000 is capable of
controlling two cash drawers independently through software command.
WALL MOUNTING
The main part in the wall mounting kit is a bracket as shown in the picture.
When mounting the TP-6000 bracket to a wall, be sure that the widest part of each of
the four holes faces in the upward direction (see picture below). Align the four
matching pegs on the back of the main unit to the four matching holes in the bracket
to hold the main unit in a similar manner as installing the main unit onto the stand
assembly. The stand assembly is not used with a wall mount installation.
LOCATION FOR INSTALLATION
Since the stand assembly is not involved in wall mount installation, only the
space required for wall mount application will be taken into consideration. The space
required is 375 mm in width and 315 mm in height.
For desk top/counter applications, the adjustable stand assembly requires a
base 270 mm deep and 260 mm wide. However, please take the main unit into
consideration. If the main unit is tilted to the near vertical position, the total height can
Wall Mount Bracket
Matching Holes
Screw At Screw Holes Through Matching Holes