Mustek TP-6000 - Manual (Page 16)

TP6000 USER’S MANUAL 3 - 4
PREPARING THE MAIN UNIT
On the back of the main unit, there are 4 matching pegs and a service window.
Push the service window open, in the direction indicated in the picture. Below, one
can find a button cell battery socket, a 1 x 3 header (JP10) with 1 jumper and a 2 x 3
header (JP8) with 2 jumpers.
This battery socket requires a 3V button cell Lithium battery (CR2032) to
support the system clock. The jumpers in this window are designated for COM port
power supply and UPS battery detect functions. Please contact your dealer for
technical support on setup of these jumpers. A new Lithium battery can support the
system RTC for about 3 years. After the battery is nearly exhausted, the user must
replace the battery otherwise the system RTC and system configuration setup will be
lost.
JOINING MAIN UNIT AND STAND
Align the matching pegs on the back of the main unit against one of the two
sets of matching holes on the stand base. It is recommended that the terminal be
hooked onto the lower set of holes for better stability. First aim the matching pegs
Service
Window
Push Open
To The
Right
4 Matching
Pegs
Matching Holes Matching Pegs
Round Part
Slot Part
Removal
Hollow