Maxtor 1925 - Manual (Page 35)

Installation
4-10 Quickview 40 20/30/40GB AT
4.4.1 Orientation
The mounting holes on the Maxtor Quickview 40 20/30/40GB AT hard
disk drives allow the drive to be mounted in any orientation. Figure 4-6
show the location of the three mounting holes on each side of the drive.
The drive can also be mounted using the four mounting hole locations
on the PCB side of the drive.
Note: It is highly recommended that the drive is hard mounted
on to the chassis of the system being used for general
operation, as well as for test purposes. Failure to hard
mount the drive can result in erroneous errors during
testing. Drives can be mounted in any orientation. Nor-
mal position is with the PCB facing down. All dimen-
sions are in millimeters. For mounting, #6-32 UNC
screws are recommended.
Figure 4-7 Mounting Dimensions Clearance
Clearance from the drive to any other surface (except mounting
surfaces) must be a minimum of 1.25 mm (0.05 inches).
147.0
Max. 44.45
±0.25
41.28
±0.50
95.25
±0.25
101.60
±0.25
41.60
±0.25
101.60
±0.25
17.5 mm
Max.
6.35 ±0.25
28.50 ±0.50
3.18 ±0.25