Motorola GP68 - Manual (Page 32)

Model ST-865M3 SmarTrunk II ™ Logic Board
32
Table 4-1 summarizes the programmable features, the keypad
sequence for programming, and the default values as provided by the
factory.
Each feature programmed requires the following steps:
a. Enter a two digit programming code.
b. Press the # key (indicates end of programming code sequence).
c. Enter the data necessary to program that feature.
d. Press the # key (indicates end of data sequence).
Many of the programmable parameters required for proper operation
of the ST-865M3 MUST be provided by the System Operator/Manager.
These features are indicated by an asterisk (*) at the beginning of the
feature name.
After each feature is successfully programmed, a high frequency beep
will be generated. A low frequency beep indicates an error was made
in the programming sequence and the sequence should be repeated.
To return the radio to normal operation after programming is complete,
turn the power of the radio off and then back on.
See (Table 4-1) ~ Programming Options Summary Table.
4.2.1 Number of Trunking Channels
This program code sets the number of trunking chan-
nels that are used in a SmarTrunk II trunking system.
To program the number of trunking channels: Enter the
program code 10 followed by the # key, then the number
of trunking channels in your system, followed by the #
key.
Example: If your trunking system is a five channel
system press: 1 0 # 5 #.