MURO METAL PRO CH7260 User Manual
Auto feed screwdriver
Ver: 10/14/2004 1
C
C
H
H
7
7
2
2
6
6
0
0
M
M
e
e
t
t
a
a
l
l
P
P
r
r
o
o
Auto feed Screwdriver
I
I
n
n
s
s
t
t
r
r
u
u
c
c
t
t
i
i
o
o
n
n
M
M
a
a
n
n
u
u
a
a
l
l
Congratulations on your purchase of a Muro Metal Pro Auto feeding Screwdriver! You have made an excellent choice. Muro high quality
tools and screws are the professional’s choice of automatic feed screw gun systems. Muro tools provide the successful builder and
contractor the ability to give their customers the advantages of screws with speed and convenience.
IF YOU HAVE ANY QUESTIONS OR COMMENTS ABOUT THIS OR ANY OTHER MURO TOOL, CALL US TOLL FREE AT 1-
800-665-6876
Muro tools are of high quality and are easy to use, but proper operating procedures are required for maximum efficiency and satisfaction.
Please take a few minutes to read the operational guide and safety instructions.
WARNING: Read and understand all instructions. Failure to follow all instructions listed below may result in electric shock, fire and/or
serious personal injury.
SAVE THESE INSTRUCTIONS
Keep your tool clean; remove dust and dirt by vacuuming or carefully blowing out regularly. Other tool service must be performed only
by qualified repair personnel: Service or maintenance performed by unqualified personnel could result in a risk of injury. Use of
unauthorized parts or failure to follow these Instructions may create a risk of electric shock or injury.
Hold tool by insulated gripping surfaces when performing an operation where the screws may contact hidden wiring or its own cord.
Contact with a “live” wire will make exposed metal parts of the tool "live" and shock the operator if in contact. Keep handles in good
condition, dry, clean, free from oil and grease. It is recommended to use rubber gloves if this may occur; this will also enable better control