MURO METAL PRO CH7260 - Manual (Page 9)

Ver: 10/14/2004 9
When the bit and clip are
assembled into the CH7260, it may
then be attached to the driver tool.
Rotate the attachment to allow the
small hex end of the bit to mate
with the driver. Once mated, push
the attachment fully onto the
aluminum adaptor. Latch the hasp.
. (Tip: if more latching force is
required after a period of use, the
wire part of the hasp can be bent
with pliers to re-tension the clasp. If
very badly worn, the plastic sides
may touch and some plastic must
be removed from the metal clip side
with a blade to provide clearance
for clamping.)
For Wood applications set the
screw gun torque to Max and set
the starting depth control on the
attachment to the middle of the
adjust range and adjust attachment
depth adjustment to suit.
Hex screws are normally seated
using the torque control of the
screw gun to prevent “stripping
out” or fastener breakage. Set
starting torque per chart and adjust
torque until it seats consistently.
The depth control on the attachment
is set to “deep” to allow this per
middle photo.