MURO METAL PRO CH7260 - Manual (Page 3)

Ver: 10/14/2004 3
Maintenance and Inspection of CH7260
For best results keep your CH7260 Metal Pro Clean and Free of dirt and debris for
smooth operation. Inspect and Blow out or vacuum it after use. Built up dust and dirt may
cause tool wear. To clean the tool, use a damp cloth or soap and water damped cloth, do not
use thinners or gasoline or other solvents that would damage the unit, or fully immerse it in
water, which may cause rusting. Bits are consumable and must be replaced if worn, bits are
specially designed for the Muro auto feed system.
Loading Screws in the CH7260 Metal Pro
Ensure that screws are loaded into the CH7260 with the Plastic strip facing
outwards per the diagram on the side of the screwdriver. The strips must be inserted as
shown to work properly i.e. only one way works, if inserted backwards, they will jam.
Generally, the correct end of the strip will be longer. Check that the free end of the strip fits
into the strip guide, Latch (hook) the first screw with the feed latch (Photo 2).
The strip guide supports the screw strip, assisting in keeping the screws in the correct
position for pick up by the bit, particularly for the last screws to be driven. The strip spring
acts to keep tension and a ratchet on the screw strip, also keeping the screws in the correct
position.
The strips must be
inserted as shown to
work properly i.e.
only one way works,
if inserted backwards,
they will jam. Latch
in the first screw.
1