Morphy Richards 73332 - Manual (Page 6)

66 6
SAFETY CUT-OUT
If the cleaner overheats, a
motor protection thermostat will
automatically switch the motor
off. If this happens, switch the
cleaner off, unplug from the
power supply and leave the
cleaner to cool for at least
60 minutes . Check the
airways for blockages, empty
the dust canister and clean the
filters before restarting.
CLEANING THE
FILTERS
To maintain suction, the
pleated filter must be
shaken clean each time the
dust canister is emptied.
Failure to clean the filter will
reduce suction and could
damage the motor if used for a
prolonged period. This may
invalidate the guarantee. If the
filters become damaged, they
must be replaced.
Pleated filter
This must be shaken clean at
every emptying to maintain
suction. To thoroughly clean it,
wash it regularly.
To remove it from the dust
canister lid, turn the filter
quarter-of-a-turn anti-clockwise
H . Wash in warm water (no
detergent) and allow to air dry
before refitting.
Motor protection filter
I
The motor protection filter ı is
located underneath the dust
canister.
1 Remove the dust canister.
2 Lift out the filter and shake over
a dustbin.
The filter may also be washed in
water (no detergents). Allow the
filter to air dry. Ensure the filter
is thoroughly dry before refitting.
3 Replace the filter.
Exhaust filter
J
The exhaust filter is located
below the dust canister
compartment.
1 Remove the front cover ‹.
2 Remove the exhaust filter ˆ by
pulling forward at the top and
lifting it away.
3 Take the filter out of the cage
and shake vigorously over a
dustbin. The filter may also be
washed in warm water. Do not
use detergents. The filter must
be completely dry before re-
fitting. Allow filters to air dry
naturally.
4 Replace the filter and the front
cover.
Changing the belt
If the brush bar stops rotating, it
is likely that the drive belt has
snapped (usually because the
brush has been stalled). A spare
belt is supplied. Replacement
belts can also be obtained from
Morphy Richards by calling the
helpline number at the base of
the page.
Accessing the floor
nozzle
K
1 Disconnect the cleaner from the
mains supply.
2 Put the switch to the ‘off’
position.
3 Remove the front cover and the
dust canister.
4 Press the handle release pedal
and place the cleaner face
down, in a flat position on a soft
surface (eg. carpet).
5 Using a flat bladed screwdriver
or a coin, rotate the three cover
fixings, a quarter-of-a-turn, from
lock to unlock K.
6 Lift the base cover ˜ from the
rear fixing area first, the cover
will rotate forward. Unhook the
cover from the front edge and
remove.
J
H
K
I
ı
UUKK HHeellpplliinnee 00884444 887711 00994499 RReeppllaacceem meenntt PPaarrttss 00884444 887733 00771155 IIrreellaanndd HHeellpplliinnee 11880000 440099 111199
ˆ
˜
Ì
73332 rev3 10/9/08 09:56 Page 6