Middleby Cooking Systems Group PS360/PS360WB - Manual (Page 30)

2-16
SECTION 2
INSTALLATION
5. Check the alignment of
the track rails using a
straightedge. The rails
MUST BE LEVEL across
the gap between the
ovens. If necessary,
adjust the oven legs to
align the track rails.
Figure 2-19
Checking Track Rail Alignment
6. Tighten all of the attaching bolts. Check that the mating
edges of the ovens align properly. If gaps appear between
the tops of the ovens, it will be necessary to loosen the
connecting bolts and realign the ovens.
IMPORTANT: If it is necessary to realign the ovens,
remember to re-check the alignment of the track rails.
7. Attach the front trim strip
between the two ovens, as
shown in Figure 2-20.
Figure 2-20
Trim Strip Positioning
Trim strip
8. Perform one of the following, as appropriate:
• For PS360/360WB Tandem and Double Tandem
installations, skip ahead to the INSTALLING THE
CONVEYOR FRAME AND BELT section (Page 2-19).
• For PS360/360WB Tri Tandem installations, perform
Steps 1-7 again to attach the third oven to the two that
have just been assembled. Then, skip ahead to the
INSTALLING THE CONVEYOR FRAME AND BELT
section (Page 2-19).
• For PS360/360WB Quad Tandem installations, perform
Steps 1-7 again to attach the two remaining ovens to
each other. Then, continue on to Step 9 to attach the
center (transition) section.