Motorola XU2100 - Manual (Page 17)

31
Pr
ogramming Fe
atur
es
X
Programming Features
You can change the following features by entering the programming mode (k).
To talk with someone on your two-way radios, these settings must match:
•
Channel (XU2600 and XV2600 only)
• Frequency
• Interference Eliminator Code
• Scramble code
• Bandwidth (for optimal clarity)
You can also use k to set the following:
•
Call tones
• Microphone Gain
• Scan List (XU2600 and XV2600 only)
• Available channels (XU2600 and XV2600 only)
Note: You cannot enter kwhile a VOX accessory is plugged into the radio.
Entering Programming Mode
You must enter Programming Mode to change your communication settings.
1. Press and hold MJ for three seconds while turning on your
radio. The radio beeps and displays k.
1
Pr
og
ramming F
eatur
es
32
X
Programming a Channel (XU2600 and XV2600 only)
Each channel has its own Frequency, Interference Eliminator Code, Scramble Code,
and Bandwidth Settings.
Program each channel separately.
1. Select the channel that you will be programming.
2. The channel number flashes. l and code displays
alternately.
3. Press [ or ] to select the desired channel.
4. Press and hold M to exit k, or press \ to continue.
Programming the Frequency
Sets the frequency that your radio will use. As you are matching your
XTN radio to existing Spirit M-Series radios, enter Programming
Mode as necessary, refer to page 34.
1. Press \to display l. The frequency flashes.
2. Press [ or ] to select the desired frequency (See
“Frequencies and Bandwidths” beginning on page 45).
3. Press and hold M to exit k, or press \to continue.
6