Metrologic Instruments MS9500 Voyager - Manual (Page 24)

18
F AILURE M ODES
Flashing Green* and one Razzberry Tone
This indicates the scanner has experienced a laser sub-
system failure. Return the unit for repair to an authorized
service center.
Flashing Red* and Green* with Two Razzberry Tones
This indicates the scanner has experienced a scanning
mechanism failure. Return the unit for repair to an
authorized service center.
Continuous Razzberry Tone with all LEDs off
If, upon power, the scanner emits a continuous razzberry
tone, then the scanner has an experienced an electronic
failure. Return the unit for repair to an authorized service
center.
Three Beeps – on power up
If the scanner beeps 3 times on power up then the non-
volatile memory (NovRAM) that holds the scanner
configuration has failed. If the scanner does not respond
after reprogramming, return the scanner for repair to an
authorized service center.
* In some custom units the standard green LED has been replaced with a blue LED and
the red LED has been replaced with a white LED.