MITSUBISHI ELECTRIC LVP-S120A - Manual (Page 11)

11
ENGLISH
Adjusting the angle of projection
Screen on a flat wall with a 90 degree angle to the floor
by adjusting two Adjustment feet on the bottom of the
projector. If the angle cannot be corrected by them,
adjust the height and angle of screen.
1. Lift the projector to the right angle.
2. Press the release button for angle adjustment to take
the Adjustment foot (up and down) out of the pro-
jector.
3. Release the button and keep your hands away from
the projector.
4. Turn the foot to right or left to adjust for proper
angle.
After using the projection,
5. Press the release button to take the projector down
slowly with holding it.
When the left and right angles are different
Adjust the angles with adjustment feet (right and left),
which are on the bottom of the projector. When ship-
ping the projector at first, the Adjustment feet are cov-
ered with sponge to be parallel on a flat surface. Re-
move the sponge to adjust the Adjustment feet lower.
Do not lose the sponge.
• Screen on a flat wall with a 90˚ angle to the floor.
• Align projector to produce a full screen display as
illustrated on page 10.
• Distance from projector to screen must be
compatible with screen size chart on page 10. Note
distance from screen chart.
Getting ready for projection
1. Connect the power cord provided to the projector.
2. Connect the power cord to the wall outlet.
3. Take off the lens cap.
Warning:
• Do not look directly into the lens when projector is
“ON”.
• The lens cap is for protecting the lens. If you leave
the power on with the cap on, the cap may be warped.
Please remove the lens cap when you turn the power
on.
• A three-pin grounding type power plug is used with
the projector. Do not remove the grounding pin on
the power plug. If you are unable to insert the plug
into the outlet, contact your electrician to replace
your A/C obsolete outlet.
• The supplied power cord is used for 120V only. Never
connect to any outlet or power supply having a dif-
ferent voltage or frequency. If you connect to the
power supply having a different voltage, please use
the appropriate power cord.
• Do not place an object on the power cord and keep
the projector away from heat source to avoid break-
ing the power cord. A broken power cord can cause
fire or electric shock.
• Do not revise or alter the power cord otherwise it
may cause fire or electric shock.
Contact your dealer if the cord is broken.
Caution:
• Plug in firmly and unplug by holding the plug, not
by pulling the cable out.
• Do not plug in or out with wet hands. It may cause
an electric shock.
Plug in the provided
power cord directly.
ground
terminal
Adjustment foot
(up and down)
screen