Middleby Marshall PS300F - Manual (Page 11)

ENGLISH
11
Figure 2-9 - Bolts and Spacers
Figure 2-10 - Aligning the Sections
4. Insert three of the supplied 1/2 x 5” bolts through the holes
in the frame of the right oven, pointing outward as shown in
Figure 2-9. Then, slide the spacers into place on the bolts.
5. Push the ovens together. Check that the mounting bolts,
alignment plate, and sealing gasket are all properly aligned.
See Figure 2-10.
6. Tighten all of the attaching bolts. Check that the mating
edges of the ovens align properly. If gaps appear between
the tops of the ovens, it will be necessary to loosen the
connecting bolts and realign the ovens.
Figure 2-11 - Trim Strip Installation
Trim strip
7. Attach the front trim strip between the two ovens, as shown
in Figure 2-11.
8. Replace the rear axial cooling fans. See Figure 2-8.
2-1/2" x 2-1/2"
(64x64mm)
spacers
2-1/2" x 8"
(64x203mm)
spacers
SECTION 2 - INSTALLATION