Moyer Diebel 301HT - Manual (Page 11)

3
!
INSTALLATION (CONT.)
PLUMBING CONNECTIONS (CONT.)
Drain Connections
1. Drain hose must be supported by bracket provided (shipped inside of machine).
2. The drain hose bracket must be mounted a minimum of 2 feet above the finished drain,
either on the rear of the machine or on the wall.
3. The maximum height of the drain from the floor must not exceed 3 feet.
4. Connect the 3/4"I.D. flexible reinforced drain hose to a 1-1/2" wye (Y) drain fitting. Use a
3/4" hose adapter (supplied by others). Do not connect drain hose to a 90° drain fitting.
DETERGENT
The machine is equipped with an automatic detergent dispensing pump system.
1. Use a qualified detergent/chemical supplier for your detergent and rinse aid needs.
2. Your machine is supplied with a detergent dispensing pump that is internally wired and ready
for use. Use a commercial grade liquid detergent and insert the red pickup tube into the
detergent container. The pickup tube has a strainer on the end to prevent the crystallized
chemical from clogging the supply lines.
CAUTION:
Always wash the hands under running water if they come into contact with the detergent and
comply with the specific instructions pertaining to the specific type of detergent.
NOTE:
A nonchlorinated detergent is recommended for your dishwasher.
To prime the peristaltic pump:
1. Insert pump inlet hose into the detergent container.
2. Close machine door and switch machine on.
3. Allow wash tank to fill and run machine cycles until chemical enters machine.
RINSE AID
1. Use a qualified/chemical supplier for your rinse aid needs.
2. Insert the transparent tube into the container containing the rinsing agent.
3. Prime the rinse aid pump while machine is in cycle by pressing and depressing power button
until the transparent tube has completely filled.
3. Start the machine as described the "OPERATION SUMMARY" on page 5. The dispenser
will pump about 3cc of liquid from the container.
INSTALLATION