Motorola WA840G - Manual (Page 61)

TROUBLESHOOTING SECTION 4
WA840G 4-3
Software Solutions
I would like to see if my Internet connection is live.
Use the ping command to test the connection. Before attempting,
ensure that Obtain an IP address automatically has been selected
in the computer’s settings
and that you have an IP address assigned.
Refer to Configure Your Computers in Section 2: Configuration, for
further details.
1 Open a command prompt by clicking Start and Run.
2 For Windows 98 and ME, in the Open field, type command and
press Enter or OK.
For Windows 2000 and XP, type cmd. Or, navigate using your
Start button to Programs>Accessories>Command Prompt.
3 In the Command window, type ipconfig.
! You should see an IP address for your network adapter:
Ethernet Adapter Local Area Connection:
Connection-specific DNS Suffix.: Example.example.example.com.
IP Address. . . . . . . . . . . . : 192.168.40.10
Subnet Mask . . . . . . . . . . . : 255.255.255.0
Default Gateway . . . . . . . . . : 192.168.40.1
4 In the Command window, type ping followed by the access
point’s IP address and press Enter. For example type:
ping 192.168.40.10.
There is a good possibility that the Default Gateway’s IP address
is the access point’s IP address. You can verify the access point’s
IP address on the Control Panel > Network Access screen.
! If you receive a reply (the first word will be Reply…), then
your computer is connected to the access point. Proceed to
Step 5.
! If you do NOT receive a reply, repeat steps 1 – 4 on a
different computer to verify that the first computer is not the
cause of the problem.
5 In the Command window, type ping followed by your ISP’s
default gateway and press Enter. For example type:
ping 216.109.125.72.