Metrik Mobile Electronics MCD795 - Manual (Page 7)

Page 6
During MP3 mode, press the RPT button and hold for more than 0.5 seconds
to play the current folder repeatedly. Press again to cancel this function.
Press the RDM button to play all tracks on disc in random order.
Press again to cancel this function.
During MP3 mode, Press the RDM button and hold for more than 0.5 seconds
to play the track in random order in the current folder.
Press again to cancel this function.
c) During the normal playback of CDs in MP3 format:
Press the radio preset button 6 and 5 to move up and down10 tracks at a time.
19. SCAN BUTTON
Press the SCN button to scan the radio frequency. If a valid signal has detected,
the current frequency will be hold and blinked for 5 seconds, then press SCN
again to stop scan and remain the current frequency; otherwise, the radio will
go on to scan the other radio frequency fiver seconds later.
20. LOC BUTTON
Radio station search mode is divided by this LO/DX switch, this button can be
used to control an attenuator in the tuner during search. The detecting level
of seek, scan, auto-memory will be reduced as much as the attenuated level
of the tuner. In radio mode, press the LOC button to change local reception or
distance reception. Note: This button is only for FM reception. In AM mode,
LOC is void.
21. ST/MO BUTTON
In radio mode, press the ST briefly to select stereo or mono sound mode.
22. LOUDNESS BUTTON
When press shortly, the LOUD mode is turned on, its to enhance the bass sound
effect when the volume level is low. Press again to cancel the loudness effect.
23. CLOCK BUTTON
Press the CLK button briefly to display time for 5 seconds on the display, and
then returns to its previous display unless the button is pressed again.
Then press the CLK button and hold for more than 1 seconds until the real time
flashes on the display. Then you can adjust HOUR or MINUTE by rotating the
VOL knob.
24. EJECT KEY
In the power on state, the loaded disc can be ejected by pressing the EJ key.
25. CD SLOT
26. FLASHING LED
When the front control panel is removed this indicator flashes.
Note:
1.Make sure use
ONLY speakers with 4 ohm load impedance.
2.Do not allow the auto antenna wire and ground touch each other.
WIRING DIAGRAM
Page 9
+
+ +
+
YELLOW
ANTENNA PLUG
CONSTANT B+
BLACK(GND)
IGNITION SWITCH
RED (B+)
FRONT
REAR
RIGHT
FRONT WHITE
WHITE/BLACK
GREEN/BLACK VIOLET/BLACK
GRAY/BLACK
GRAY
VIOLET GREEN
REAR
LEFT
LOUDSPEAKER
- -
- -
BLUE POWER ANT
FUSED
10A & 0.5A
FUSES
FILTER BOX
LOUDSPEAKER
RED R
WHITE L
FUSE 0.5A
RCA LINE OUT
REAR (GRAY)
RCA LINE OUT
FRONT (BLACK) RED R
WHITE L