Metrik Mobile Electronics MCD795 - Manual (Page 8)

Page 8 Page 7
OPERATION OF REMOTE CONTROL:
Note:
Before use this remote control, please make sure
turn on the device by pressing the power button on
the front control panel.
1. Power On/Off.
2. Mute Button
3.
4. Level/MENU UP Button 5. SEL/MENU
Loudness Button
Button
6. Level/MENU Down Button 7. MO/ST Button
8. A.P Button 9.Band Button 10. Mode Button
11.Tune/Seek Up And Track Skip Up/FF Button
12.Tune/Seek Down And Track Skip Down/REW Button
13. SCAN BUTTON 14. Clock Display /Setting Button 15. LO/DX Button
16. CD Track TOP/ /Radio Preset 1 17. CD Track INT/Radio Preset 2
18. CD Track RPT/Radio Preset 3 19. CD Track RDM/Radio Preset 4
20. Radio Preset 5 21. Radio Preset 6
Before using the remote control, pull out the insulating patch. This patch
was installed to insulate the battery from draining until ready to use.
BATTERY INFORMATION:
Lithium Battery: CR2025 3V
Battery Life: Approximately 6 months.
Replacing the Battery from the Remote Control:
1) Remove the battery holder by pressing the locking tab with your thumb
and pulling it out.
2) Replace the battery with the same type and the
+ side facing up.
3) Gently push in the holder until securely locked into place.
WARNING:
Do not recharge, disassemble or dispose of in fire.
Battery leakage may cause damage to the unit.
To avoid the risk of accident, keep batteries out of reach of children.
MAINTENANCE OF REMOTE CONTROL
27. RESET BUTTON
Before operating the unit for the first time, or after replacing the car battery or
changing the connections. You must reset the unit.
Press this button with a cuspidal object. This operation will erase the clock
setting and some stored contents.