Meridian America DSP8000 - Manual (Page 33)

29
Configuring
the DSP8000
loudspeakers
To adjust the centre frequency
response and tilt offset
If your system includes a DSP centre speaker you
should set Centre Y on the master speaker. An
additional frequency response option is then provided to
allow you to adjust the centre speaker, with the options:
C.Free, C.Boun., C.Sub 1, C.Sub 2, and
C.Corner.
Press Function > or Function < until the display
shows the current centre frequency response.
For example:
C.Free
Press Function A or Function V to select the
appropriate option for the centre speaker.
An additional centre tilt offset option is also provided.
The centre tilt offset is added to the treble value for
the selected source. The recommended setting is -1dB
when the speaker is positioned above a television.
Press Function > or Function < until the display
shows the current centre tilt offset.
For example:
C.Tilt+1
Press Function A or Function V to adjust the
centre tilt offset.
To specify the ambient temperature for
thermal protection
The DSP8000 drive units are protected from
overheating by thermal protection software. This is
already configured correctly for most domestic listening
environments, but if the ambient temperature is greater
than 24°C (75°F) you should adjust the ambient
temperature setting.
•
•
•
•
Press Function > or Function < until the display
shows the current ambient temperature setting.
For example:
24
Press Function A or Function V to specify the
ambient temperature.
When thermal protection is active the lower left green
indicator will be illuminated.
To store the settings
Once you have adjusted the frequency response for the
speakers in your system you should store the settings
using the following procedure:
Press Function Store.
The display shows: Store
Turn off the DSP8000 loudspeaker using the power
switch on the back panel.
When you turn on the power again the speaker will
operate normally with the setting you have stored.
•
•
•
•