Minolta E260 - Manual (Page 95)

Waiting
The printer has received a job to print, but is waiting for additional data.
Try one or more of the following:
• Press to print the contents of the buffer.
• Cancel the current print job.
31.yy Replace defective or missing cartridge
The toner cartridge is either missing or not functioning properly.
Try one or more of the following:
• Remove the toner cartridge, and then reinstall it.
• Remove the toner cartridge, and then install a new one.
32.yy Cartridge part number unsupported by device
Remove the toner cartridge, and then install a supported one.
34 Short paper
Try one or more of the following:
• Load the appropriate paper in the tray.
• Press to clear the message and print the job using a different paper tray.
• Check tray length and width guides and make sure the paper is properly loaded in the tray.
• Check the Print Properties or Print Dialog settings to make sure the print job is requesting the correct paper size
and type.
• Check that the paper size is correctly set. For example, if the Manual Feeder Size is set to Universal, make sure the
paper is large enough for the data being printed.
• Cancel the current print job.
37 Insufficient memory to collate job
There is not enough memory to collate the print job. Try one or more of the following:
• To print the portion of the job already stored and begin collating the rest of the print job, press .
• Cancel the current print job.
38 Memory full
Try one or more of the following:
• Press to clear the message and continue printing. The job may not print correctly.
• Cancel the current print job.
• Install additional printer memory.
Understanding printer messages
95