Mace CAM91 User Manual
Page 16
Operating Your Camera
30
Day&Night Color CCD Camera
31
Day&Night Color CCD Camera
Operating Your Camera
2. Specify the zone area.
You can specify the zone area by setting a proper value from 0 to 15 with an
increment of 1. Move the arrow indicator to ‘Top’ using the UP or DOWN
button and increase or decrease the value using the LEFT or RIGHT button.
Repeat the procedure for bottom, left, and right.
3. Adjust Sensitivity
Move the arrow indicator to ‘Sensitivity’ using the UP or DOWN button, then
press the LEFT or RIGHT button to decrease or increase the value.
If you decrease the sensitivity, the camera will detect only motion that is
clearly noticeable.If you want to set the camera to detect minor motion,
increase the sensitivity.
You can select the sensitivity from 0 to 15.
Higher sensitivity detects smaller motions at the risk of false detection.
Therefore zone adjustment is recommended rather than sensitivity adjustment.
4. Adjust the output signal.
POSI(Positive) : When a motion is sensed, +5V of Pulse will be output
NEGA(Negative) : When a motion is sensed, 0V of Pulse will be output
ALARM : You can connect external equipment like buzzer or lamp. The output
of alarm is an open collector under DC16V & 100mA capacity.
Tips on using Motion Detection
After selecting zone and sensitivity, perform a test operation to make sure it
works properly.
If the lighting flickers, the motion detection feature might not work properly.
This system does not guarantee prevention of fires or thefts. The manufacturer
is not responsible for any accident or damage.
Color (Day & Night)
Your camera provides automatic mode changeover by sensing day or night
conditions. It changes to Color mode in day conditions for optimal color and to
B/W mode in night conditions for clear identification.
1. Press the SET button to display the setup menu and move the arrow indicator
to ‘Color’ using the UP or DOWN button.
2. Select a mode using the LEFT or RIGHT button.
ON : Color mode is kept up.
B/W : Black and white mode is kept up.
AUTO : The mode is changed between Color and B/W automatically
depending on the brightness.
Pushing the SET button at Auto mode, you can control the mode
changing point and time and burst existence during the mode
change to B/W mode.
Select the AUTO, ON, BW, EXT.
using the LEFT or RIGHT button
Setup
Camera ID
BLC
Lens
Shutter
Gain
White Balance
Motion Detect
Color
Sync.
Reset
End
OFF
OFF
DC
OFF
AGC
ATW
ON
AUTO
INT