Micron Technology Turbofan User Manual
Page 6
DRAFT
5
4.0 INSTALLATION
The design of a sprayer incorporating Turbofan Sprayheads will vary according to the
crop to be sprayed, the type of sprayer being used and the available hydraulic power.
This section gives general advice and design data but is not intended to provide specific
instructions for building every type of sprayer. Original Equipment Manufacturers
(OEMs) should contact Micron if they require any further information for a particular
application.
4.1
Mounting of Sprayheads
The configuration of a sprayer and mounting of sprayheads will depend upon the type
and planting of the crop to be sprayed. Some examples of typical configurations are
shown in Figures 2, 3 and 4.
Figure 2. Typical sprayhead configuration for ground crops
Figure 3. Typical sprayhead configuration for grape harvester mounting (4 rows)