Meco Assie Vantage LP 67c3c8kk81 - Manual (Page 10)

10
D
Step 10
Side Burner Igniter Wire Connection
The Side Burner Igniter Wire is pre-installed and connected to
the Ignition Box. Attach the wire to the Side Burner electrode by
sliding the wire connector onto the electrode terminal.
Underside view of
Side Table/Side Burner
Note:
Shown without Regulator
Hose for clarity.
Valve
A
5/32 x .31” Bolt
2 pc
B
Venturi
Windscreen
Side Burner
Bracket
Step 9
Side Burner Valve Assembly
NOTE: Side Burner Valve is already attached to the regulator hose. Hose is not shown in some illustrations for clarity.
A. Install the Side Burner Valve from underneath the LEFT Side Table. Remove the screws from the side burner bracket
and set aside with bracket.
B. Tilt venturi end of burner down. Rotate the rectangular venturi windscreen sideways and slide toward back of grill to
expose open end of burner tube.
C. Insert the valve stem out through the hole in the bezel and fascia on the front of the side table. Next insert the
nozzle into the opening in the burner tube.
D. Attach the valve to the front of the side table by installing two 5/32” x .31” Bolts through the Control Knob Bezel and
front of the Side Table into the threaded Valve bracket holes. Slide the windscreen back into position and replace the side
burner bracket.
C
C