Minicom Advanced Systems Smart CAT5 - Manual (Page 33)

USER GUIDE
32
5.4 Password protection
When the Smart CAT5 system is password protected, the Control software behaves in
exactly the same way as the OSD. You must type in the required password to access
the Control software. The access you gain depends on the security status – exactly as
with the OSD.
To change the security access, close and reopen the Control software, and type in the
different password.
5.4.1 Administrator (Status A)
The Administrator can:
· Set and modify all Passwords and security profiles
· Fully access any computer
· Use all functions
5.4.2 Supervisor (Status S)
The Supervisor can:
· Fully access any computer
· Scan computers.
5.4.3 User (Status U)
There are 6 different Users in the Smart CAT5 system. Each User has a Profile that
defines the access level to different computers. There are 3 different access levels.
These are:
· Y – Full access to a particular computer
· V –Viewing access only, to a particular computer (No keyboard/mouse
functionality)
· N – No access to a particular computer
The Administrator defines the desired access levels of each User Profile. This is done
in the Setting box. By default the User Profile settings are full access.