Minicom Advanced Systems Smart CAT5 - Manual (Page 5)

USER GUIDE
4
1. Wel c om e
Thank you for buying the Smart CAT5 Switch system. This system is produced by
Minicom Advanced Systems Limited.
Technical precautions
This equipment generates radio frequency energy and if not installed in accordance
with the manufacturer’s instructions, may cause radio frequency interference.
This equipment complies with Part 15, Subpart J of the FCC rules for a Class A
computing device. This equipment also complies with the Class A limits for radio
noise emission from digital apparatus set out in the Radio Interference Regulation of
the Canadian Department of Communications. These above rules are designed to
provide reasonable protection against such interference when operating the equipment
in a commercial environment. If operation of this equipment in a residential area
causes radio frequency interference, the user, and not Minicom Advanced Systems
Limited, will be responsible.
Changes or modifications made to this equipment not expressly approved by Minicom
Advanced Systems Limited could void the user’s authority to operate the equipment.
Minicom Advanced Systems Limited assumes no responsibility for any errors that
appear in this document. Information in this document is subject to change without
notice.
No part of this document may be reproduced or transmitted in any form or by any
means, electronic or mechanical, for any purpose, without the express written
permission of Minicom Advanced Systems Limited.
© 2007 Minicom Advanced Systems Limited. All rights reserved.
Trademarks
PS/2 is a registered trademark of International Business Machines Corporation. All
other trademarks and registered trademarks are the property of their respective
owners.