Mercedes-Benz 2005 C 230 Kompressor - Manual (Page 108)

107
Controls in detail
Memory function*
̄ Memory function*
You can store up to three different settings
per SmartKey.
The following settings are saved for each
stored position:
ț Driver’s seat, backrest and head
restraint position
ț Steering wheel position
ț Exterior rear view mirror positions
These key-dependent memory settings
can be deactivated if desired. For informa-
tion on key-dependent memory settings,
see “Setting key-dependency”
(
୴ page 149).
The following settings are not
key-dependent. They are stored when
using the buttons on the passenger door:
ț Front passenger seat, backrest and
head restraint position.
!
Prior to operating the vehicle, the driv-
er should check and adjust the seat
height, seat position fore and aft, and
seat backrest angle if necessary, to en-
sure adequate control, reach and com-
fort. The head restraint should also be
adjusted for proper height. See also the
section on air bags (
୴ page 61) for
proper seat positioning.
In addition, adjust the steering wheel to
ensure adequate control, reach, opera-
tion and comfort. Both the interior and
exterior rear view mirrors should be ad-
justed for adequate rear vision.
Fasten seat belts. Infants and small
children should be seated in a properly
secured restraint system that complies
with U.S. Federal Motor Vehicle Safety
Standards 213 and 225 and Canadian
Motor Vehicle Safety Standards 213
and 210.2.
Warning!
G
Do not activate the memory function while
driving. Activating the memory function
while driving could cause the driver to lose
control of the vehicle.