Mercedes-Benz 2005 C 230 Kompressor - Manual (Page 294)

293
Operation
Engine compartment
Checking engine oil level with the
control system
When checking the oil level
ț the vehicle must be parked on level
ground.
ț with the engine at operating tempera-
ture, the vehicle must have been
stationary for at least five minutes with
the engine turned off.
ț with the engine not at operating tem-
perature yet, the vehicle must have
been stationary for at least 30 minutes
with the engine turned off.
To check the engine oil level via the
multifunction display, do the following:
̈ Switch on the ignition ( ୴ page 33).
The standard display ( ୴ page 123) should
appear in the multifunction display.
̈ Press button k or j on the
steering wheel until the following
message is seen in the multifunction
display:
One of the following messages will
subsequently appear in the indicator:
ț Engine oil level
OK
ț Add 1.0 qt engine oil
for max. oil level
(Canada: 1.0 l )
ț Add 1.5 qts engine oil
for max. oil level
(Canada: 1.5 l )
ț Add 2.0 qts engine oil
for max. oil level
(Canada: 2.0 l )
̈ If necessary, add engine oil.
For adding engine oil, see ( ୴ page 294).
For more information on engine oil, see
“Technical data” section (
୴ page 426) and
( ୴ page 428).
Other display messages
If the SmartKey is not turned to position 2
in the starter switch, the following
message will appear:
Switch ignition on to
check engine oil level
̈ Switch on the ignition ( ୴ page 33).
i
If you want to interrupt the checking
procedure, press the
k or j
button on the multifunction steering
wheel.