Motorola L3392 - Manual (Page 123)

Troubleshooting 8-7
The external monitor displays nothing.
l Make sure that the monitor is turned on.
l Make sure that the monitor’s signal cable is properly connected.
l Check if the Setup item Display Mode on the Main menu of the SCU
program is configured correctly.
l Switch the display to the monitor by pressing Fn + F9 or through the
Windows’ Display properties.
Simultaneous display does not work.
l Make sure that you turn on the external monitor before turning on the
computer.
l Check the Setup item Display Mode on the Main menu of the SCU
program is configured correctly.
l Press Fn + F9 or use Windows’ Display properties to select the display
options.
Floppy Disk Drive Problems (on optional docking station)
The Floppy Disk Drive In-use Indicator stays on.
l Make sure that the floppy disk is not physically damaged.
l Make sure that the floppy disk is inserted correctly.
The disk drive cannot write to a floppy disk.
l Make sure that the floppy disk is formatted.
l Make sure that the floppy disk is not write-protected.
l Make sure that you are writing to the correct drive.
l Make sure that there is enough space left on the floppy disk.
l Make sure that the floppy disk is not physically damaged.