Motorola L3392 - Manual (Page 86)

Setup Configuration Utility 5-10
Set Password
allows you to set the password for your system. When
typing password, first make usre that
Num Lock is off, then type your
password in the entry fields and press
Enter. Confirm your password by
typing it again and pressing
Enter. If the Enable Password to Power-on
sub-item is enabled, the set password is always required to boot the
computer.
Hard Disk Boot Sector
sets if a warning message will appear when
the hard disk boot sector (partition table) has been changed. A check
mark (ü) indicates enabled, while an underline (_) indicates disabled.
The default setting is disabled.
CAUTION: sets this item to disabled before installing an operating system, running
Fdisk or Format program. Otherwise, the intended action will fail.