Multi-Tech Systems MT5600DSVD - Manual (Page 24)

MultiModemDSVD User Guide 3 Operation
19
Fax Operation
Using the PhoneTools program included with your modem, you can use your modem
to send and receive faxes directly from your computer. The following procedure uses
print capture, which enables you to fax a document directly from the Windows ap-
plication in which you created it without opening PhoneTools.
1. Create a document in a Windows application, such as a word processor, graphic
editor, or spreadsheet. To fax the document, keep the application and the docu-
ment open and select the Print command from the File menu.
2. Select CAPTURE FAX BVRP as the printer driver, and then click OK. The Send
Fax wizard appears.
3. In the Recipient section, type the required information or extract it from the
Phone Book by clicking .
4. In the Template section, optionally select a cover page and type a cover message.
5. Select the document to be sent. The default file when sending from within a Win-
dows application is Capture.dgr.
6. Select the date and time to send the document, if you do not want to send it
immediately.
7. Click Finish to start the transmission.
Voice Operation
Operation in DSVD mode allows data transfer and voice conversation to occur si-
multaneously during a data connection. On a DSVD call, a headset or microphone
and speaker can be used as the voice interface. Both local and remote modems must
have compatible DSVD technology to support the DSVD function. DSVD can be
used by running a communications application that supports DSVD. Follow the ap-
plication instructions. DSVD can also be controlled manually issuing AT commands
to the modem as described in the following sections.
To Originate a Voice Call in Speakerphone Mode
1. In the terminal window of your communications application, type AT and press
E
NTER
. The modem will respond with OK.
2. Type AT&F and press E
NTER
to reset the modem to its default configuration.
3. Type AT#CLS=8#VRN=0#VLS=6 and press E NTER to initialize the modem for
speakerphone mode.
4. To dial, type ATDTnnnnnnn and press E
NTER
, where nnnnnnn is the phone num-
ber of a remote party. The modem will report VCON at the completion of dialing
to indicate the speakerphone is on.
5. To hang up, type +++ATH and press E NTER .