Four-wire setup – Multitech MULTI MODEM II MT5600BA User Manual
Page 74
7 Leased Line Operation
68
MultiModemII User Guide
10. This completes the setup for two-wire leased line operation. Upon completion,
the modem attempts to connect to the modem at the other end of the leased line.
If the remote modem has not yet been configured for leased line operation, you
may turn off the local modem until the remote one is ready.
Four-Wire Setup
1. For four-wire leased line operation, connect one of the provided four-wire cables
to the LEASED jack on the back of the MT5600BL modem. Connect the other
end of the cable to a four-wire leased line jack or terminals supplied by the
telephone company.
2. Turn on the modem.
3. Starting at the STATUS screen, press the following buttons on the front panel:
в, а, в, в, в, а, а, а, а. The SYNC, NORM? screen appears.
4. Press the Enter button to select normal synchronous operation.
5. The OPTION SET screen appears. Press
áß to exit to the SYNC/ASYNC
OPTIONS
screen.
6. Press
бЯ, бЯ, бЯ, а, а, а, а, а, а. The 4 WIRE LEASE? ORIG screen
appears.
7. Choose one of two actions:
• To set up the modem as the originate modem, press the Enter button.
• To set up the modem as the answer modem, press
à to display the
4 WIRE LEASE? ANSWER
screen, and then press the Enter button.
Note:
One of the modems in a leased line pair must be configured as the origi-
nate modem, and the other as the answer modem, but it does not matter which
is which.
8. The OPTION SET screen appears. Press
áß to exit to the ONLINE OPTIONS
screen, or
à to exit to the CURRENT SETTING= screen.
9. This completes the setup for four-wire leased line operation. Upon completion,
the modem attempts to connect to the modem at the other end of the leased line.
If the remote modem has not yet been configured for leased line operation, you
may turn off the local modem until the remote one is ready.