Multitech MULTI MODEM II MT5600BA - Manual (Page 64)

5 Remote Configuration
58
MultiModemII User Guide
3. To change the password, press áß or â to select the first character of the pass-
word, and then press à to go to the next character. Repeat until you have entered
the entire password.
4. To cancel the new password, press à until the password is erased. To save the
new password, press the Enter button. The next time you remotely configure the
modem you must use the new password.
Changing the Remote Escape Character
To improve security, you can change a remote modem’s remote configuration es-
cape character. The remote configuration escape character is stored in register S13.
The factory default is 42, which is the ASCII code for the asterisk character (*). Set-
ting S13 to 0 (zero) disables remote configuration entirely—but if you do this re-
motely, you won’t be able to change it back remotely!
1. Establish a remote configuration link with the remote modem as described in
“Basic Procedure.”
2. Type ATS13=n, where n is the ASCII code for the new remote configuration es-
cape character, and then press E
NTER
.
3. Save the new value by typing AT&W and pressing E NTER .
4. Type ATO<CR> to exit remote configuration.