McIntosh C2200 - Manual (Page 23)

23
How to Operate by Remote Control
The supplied Remote Control is capable of directly control-
ling the functions of contemporary McIntosh Source Com-
ponents connected to the C2200. Earlier McIntosh source
components and other brand source components can be con-
trolled by the C2200 with the addition of a McIntosh Re-
mote Control Translator (RCT).
Note: Your McIntosh Dealer can assist you with the
installation and operation of the Remote Control
Translator (RCT).
Mute
Press the MUTE Push-button to mute audio at the all the
Preamplifier Outputs, except the TAPE OUTPUTS. Press
MUTE a second time to unmute audio.
Mono
Press the MODE Push-button to combine Left and Right
Stereo Signals to Mono at all the Preamplifier Outputs, ex-
cept the Tape Outputs.
Trim and Level
Press the TRIM Push-button to active the Input TRIM
Function. Press the LEVEL Up
and Down Push-but-
tons to Trim the Input Sound Level. For additional informa-
tion refer to page 15.
Input Source Selection
Press any of the eight Input Push-buttons to select a pro-
gram source.
CD/Tape Functions
Use these push-buttons to operate a CD Player, CD
Changer or Tape Recorder.
Numbered Push-buttons
Press Push-buttons 0 through 9 to access tuner station pre-
sets or CD tracks/discs.
Disc and Track
Use the DISC and TRACK Push-buttons when a CD player
or changer is being used.
Tuner Push-buttons
Press the AM or FM Push-button to select the desired
broadcast band. Press and release the Channel Up
or
Down Push-button to move from station to station. Press
and hold a Channel Up or Down Push-button to move
continuously from station to station. Press REVIEW to start
the automatic brief audition of each of the presets stored in
the tuner memory. Press REVIEW a second time to stop on
a station preset and exit the Review process.
Volume
Press the Up
or Down VOLUME Push-button to raise
or lower the listening volume level.
Note: The TAPE OUPUTS are not affected by volume
changes.
Amplifier Selection
Press HOME Push-button followed by the SPEAKER 1 or
2 Push-buttons either separately or together, to control the
Rear Panel OUTPUTS 1, 2 Jacks.
Acc On/Acc Off
Press ACC ON to turn the power ON to a McIntosh Disc
Player. Press ACC OFF to turn the power OFF to a McIn-
tosh Disc Player.
E
Press E to perform various functions on a variety of McIn-
tosh Components. It will also pause the playing of a Disc or
Tape Player.
Lighting
Press and release the LIGHTING Push-button to momen-
tarily illuminate the upper half of the Remote Control Push-
buttons.
Note: While the LIGHTING Push-button is being depressed
the Remote Control will be unable to send a remote
command. When the LIGHTING Push-button is
released the push-buttons will continue to stay
illuminated for approximately three seconds thus
allowing you to send the desired command.
Optional Remote Control
If the C2200 is used in the Pass Thru Mode, an optional
McIntosh Remote Control Model UR12
allows use of an Alternate Set of Remote
Control Codes. This will prevent the
C2200 from responding to the McIntosh
A/V Control Center or Surround De-
coder Remote Control. See your McIn-
tosh Dealer for additional information.
How to Operate by Remote Control