MITSUBISHI ELECTRIC Mitsubishi Electric 3D Starter Pack 3DC-1000 - Manual (Page 9)

For assistance call 1(800) 332-2119
9
Using the 3D Glasses
3D Glasses Operation
1.
Turn on 3D Mode in the TV and 3D source device.
2.
Press the POWER button on the glasses to turn on the glasses.
3.
When the 3D program is complete, turn off 3D mode in the TV and
3D source device and turn off the glasses.
Press POWER button. The red
LED will light for three seconds.
On
Hold POWER button for
about two seconds. Red
LED will blink three times.
Off
50° 20 ft.
5 ft.
50°
Operating Range
Be from 5 to 20 feet away.
Notes On the 3D Glasses
• Shut off 3D glasses when not in use to extend battery life.
• Fluorescent and halogen lighting can cause the 3D glasses to
flicker. Turn off these lamps if flickering occurs.
• Turning off the TV’s 3D mode or changing the TV’s input to a 2D
input will turn off the IR emitter; the glasses will turn off automati-
cally after two minutes.
• Moving out of range of the IR emitter for more than two minutes will
cause the glasses to turn off automatically.
• Interference from other IR sources, such as motion detection
devices, may cause the glasses to flicker or work intermittently.
Turn off other IR source if interference occurs.
• The IR emitter in this system can also be used with Samsung 3D
glasses model SSG-2100AB. Information about these glasses can
be obtained from Samsung USA at www.samsung.com/usa/.
• You can also check www.mitsubishi-tv.com for any updates about
compatible glasses.