MicroNet Technology VOIP FXO SP5054A/S - Manual (Page 35)

34
2.13 [line]
Configure the Hotline, Hunt and No Answer Forward
---------------------------------------------------------------
usr/config$ line
Gateway line information and configuration
Usage:
line -config number [hunt number][hotline number]
line -print Gateway line information.
hunt Hunting group.
hotline Hot line configuration.
fwdtype forward type.
To IP:
0:disable
1:un condition
2:busy
forward forward.
Example:
line -config 1 hunt 1 hotline 1003 forward1002
---------------------------------------------------------------
Parameter Usages:
-print print out all current settings of line
-config determine which line to configure
-hunt set hunting group flag of each line.
User can assign different hunt group number represent
different hunt group. For example, if user assigns FXS TEL1
as hunt group 1, and FXS TEL2 as hunt group 2, they will be
determined as 2 different groups. On the other hand, if user
assigns FXS TEL1 as hunt group 1, and FXS TEL2 as hunt
group 1 too, when having incoming call to FXS TEL1, which is
busy, this call will be route to FXS Line2. Note: FXO Lines
and FXS TELs are treated as 2 different groups, so even they
are in the same hunt group, call will only be routed to the
same FXS or FXO Lines.
-hotline set hotline table.
The Hotline Mode is applied to the gateway will automatically
dial out a phone number. In the other hand, user will hear ring
back tone or dial tone immediately depended on
configurations of destination device.