Mitel 5212 - Manual (Page 59)

Mitel ® Model 5212/5224 IP Endpoint User Guide for Inter-Tel ® 5000 Systems 41
Ca
ll
Fe
at
ures
Remote Programming
You can use Remote Programming to access the DND and Call Forwarding features from
another system endpoint or an external phone.
3
Entering a Remote Programming Password
Before using Remote Programming, you should enter a new password.
To enter a Remote Programming password:
1. Dial 392. ENTER PASSWORD appears.
2. Enter your current password (the default password is your extension number),
followed by #. CHANGE PASSWORD TO appears.
3. Enter the new password followed by #. VERIFY PASSWORD appears.
4. Enter the new password again followed by #. DATABASE UPDATED appears.
To change the station password from another phone, see “Using Remote Programming to
Change the Password” on
page 41 .
Using Remote Programming to Change the Password
You can use Remote Programming to change the station (endpoint) password.
To use Remote Programming to change the station password:
1. Do one of the following:
• Call your DISA number (provided by your system administrator). If necessary,
enter your (DISA) password.
• Use any endpoint on the system.
2. Dial 359.
3. Enter your extension number.
4. Enter your password followed by #.
5. Dial 392.
6. Enter the new password followed by
#.
7. Enter the new password again followed by #.
3. This feature may or may not be enabled for your system.
NOTE
A Direct Inward System Access (DISA) number is required to use Remote
Programming from an external phone. Contact your system administrator for
more information.