Mitsumi electronic Untitle LDT37Iv - Manual (Page 14)

English-12
You can attach mounting accessories to the LCD monitor in
one of the following two ways:
1. In the upright position
2. Lay the screen face down
Lay the protective sheet on a table, which was wrapped around
the monitor when it was packaged, beneath the screen surface
so as not to scratch the screen face.
This device cannot be used or installed without the Tabletop Stand
or other mounting accessory. Failure to follow correct mounting
procedures could result in damage to the equipment or injury to
the user or installer. Product warranty does not cover damage
caused by improper installation.
Failure to follow these recommendations could result in voiding
your warranty.
When using with other mounting accessory, it must be a VESA-
compatible mounting method and the screws must be M6 of size
and 10mm or longer of length under consideration of the thick-
ness of the mounting method. (Recommended torque: 470 -
635N•cm). MITSUBISHI ELECTRIC recommends using mount-
ing interface that comply with TÜV-GS and/or UL1678 standard
in North America.
3. Ventilation Requirements for enclosure
mounting
To allow heat to disperse, leave space between surround-
ing objects as shown in the diagram below.
4. To avoid falling down
Fasten the LCD monitor to wall using a cord or chain,
which is sufficient to support the weight of the LCD monitor
(approx. 22kg).
Before moving the LCD monitor, the cord or chain should
be removed.
5. To prevent the main power switch from
being changed
To prevent the ability to use the main power switch, please
attach the main switch, which is enclosed as an accessory.
NOTE: With the main power switch cover in place, the main
power switch cannot be turned off. Remove main
power switch cover in order to switch off the display.
How to Mount and Attach Options to the LCD Monitor
Screw Holes
462mm
Clamper
Cord or Chain
Screw
Table
Protective Sheet
Tabletop Stand