Mitsumi electronic Untitle LDT37Iv - Manual (Page 29)

English
English-27
NOTE 1: IMAGE PERSISTENCE
Please be aware that LCD Technology may experience a phenomena known as Image Persistence. Image Persistence occurs
when residual or “ghost” image of a previous image remains visible on the screen. Unlike CRT monitors, LCD monitors’ image
persistence is not permanent, but constant images being displayed for a long period of time should be avoided.
To alleviate image persistence, turn off the monitor for as long as the previous image was displayed. For example, if an image
was on the monitor for one hour and a residual image remains, the monitor should be turned off for one hour to erase the image.
As with all personal display devices, MITSUBISHI ELECTRIC recommends displaying moving images and using a moving
screen saver at regular intervals whenever the screen is idle or turning off the monitor when not in use.
Please set “SCREEN SAVER”, “DATE &TIME” and “SCHEDULE” functions to further reduce the risk of Image persistence.
For long life use of Public Display
< Image Sticking of LCD Panel >
When LCD panel is operated continuously for long hours, a trace of electric charge remains near the electrode inside LCD, and
residual or "ghost" image of previous image may be observed. (Image Persistence)
Image Persistence is not permanent, but when fixed image is displayed for long period, ionic impurities inside LCD are accumulated
along the displayed image, and it is observed permanently. (Image Sticking)
HEAT STATUS
DATE AND TIME
SCHEDULE
ADVANCED
OPTION RESET
POWER ON DELAY
Information of status for COOLING FAN,
BRIGHTNESS and TEMPERATURE.
COOLING FAN comes to run when inside
temperature is over a guaranteed limit.
BRIGHTNESS comes to be decreased when
inside temperature is over guaranteed limit with
cooling fun.
In this case warning is displayed on the screen.
Adjusts the delay time from "standby" to
"power on" mode.
"POWER ON DELAY" time is selectable
between 0 and 50 sec.
Adjusts the current date and time for internal
clock.
You should set this function when you use
"SCHEDULE".
Programs the monitor's working
schedule.
Schedule the power on and power
off with hour and a day of the week.
Also sets the input port.
This OSD can't remove except EXIT.
(see "NOTE 2" on page 28 for further
information)
Selecting ADVANCED OPTION reset allows
you to reset all OSD settings from ADVANCED
OPTION settings, except for DATE & TIME,
and SCHEDULE.
Select "YES" and press "SET" button to restore
the factory preset data.
Press "EXIT" button to cancel and then return
the previous menu.