Memorex MLT1912 - Manual (Page 13)

12
DVD CONNECTIONS (CONTINUED)
CONNECTION USING COMPONENT CABLES:
Follow the instructions below to connect a DVD player to your television using the Y, Pb, Pr jacks.
(CABLES NOT INCLUDED.)
1. Connect the left and right audio cable from
the DVD’s AUDIO OUT jacks to the TV’s
audio left and right COMPONENT IN jacks.
2. Connect the component cables (not
included) from the DVD's Y, Pb/Cb, Pr/Cr
OUT jacks to the TV’s Component IN (Y,
Pb, Pr) jacks.
3. Press the SOURCE button until YUV
appears on the TV screen and press PLAY
on the DVD to watch a DVD.
NOTE: Connecting the DVD player to the TV
using the component cables will provide the
highest quality picture. Connecting using an
S-video cable will provide the next highest
quality picture, followed by standard Audio/
Video cable connection.
CONNECTION USING S-VIDEO CABLE:
Follow the instructions below to connect a DVD player to your television using the S-Video cable. (CABLES NOT INCLUDED.)
1. Connect the left and right audio cable from
the DVD’s AUDIO OUT jacks to the TV’s
left and right AUDIO IN jacks.
2. Connect the DVD’s S-VIDEO OUT jack to
the TV’s S-VIDEO IN jack.
3. Press the SOURCE button until S-VIDEO
appears on the TV screen and press PLAY
on the DVD to watch the DVD.
NOTE: Side panel is accessible by pressing in
on the tabs, then lift the side cover off. After
connections have been made, slide the wires
through the bottom opening of the cover and
replace cover.
Jack panel is
shown on its side.
Top of panel is
this side.